67 |
<td>Triggers a new note.</td> |
<td>Triggers a new note.</td> |
68 |
</tr> |
</tr> |
69 |
<tr> |
<tr> |
70 |
|
<td><code>change_pan()</code></td> |
71 |
|
<td>Changes panning of voices (stereo balance).</td> |
72 |
|
</tr> |
73 |
|
<tr> |
74 |
|
<td><code>change_tune()</code></td> |
75 |
|
<td>Changes the tuning of voices.</td> |
76 |
|
</tr> |
77 |
|
<tr> |
78 |
|
<td><code>change_vol()</code></td> |
79 |
|
<td>Changes the volume of voices.</td> |
80 |
|
</tr> |
81 |
|
<tr> |
82 |
|
<td><code>change_cutoff()</code></td> |
83 |
|
<td>Changes filter cutoff frequency of voices.</td> |
84 |
|
</tr> |
85 |
|
<tr> |
86 |
|
<td><code>change_reso()</code></td> |
87 |
|
<td>Changes filter resonance of voices.</td> |
88 |
|
</tr> |
89 |
|
<tr> |
90 |
|
<td><code>event_status()</code></td> |
91 |
|
<td>Checks and returns whether a particular note is still alive.</td> |
92 |
|
</tr> |
93 |
|
<tr> |
94 |
<td><code>set_controller()</code></td> |
<td><code>set_controller()</code></td> |
95 |
<td>Creates a MIDI control change event.</td> |
<td>Creates a MIDI control change event.</td> |
96 |
</tr> |
</tr> |
187 |
<td><code>%KEY_DOWN[]</code></td> |
<td><code>%KEY_DOWN[]</code></td> |
188 |
<td>This can be used in any context to check whether a certain MIDI |
<td>This can be used in any context to check whether a certain MIDI |
189 |
key is currently pressed down. Use the respective MIDI note number |
key is currently pressed down. Use the respective MIDI note number |
190 |
as index to this array variable.</td> |
as index to this array variable (see also <code>event_status()</code>).</td> |
191 |
</tr> |
</tr> |
192 |
<tr> |
<tr> |
193 |
<td><code>$VCC_MONO_AT</code></td> |
<td><code>$VCC_MONO_AT</code></td> |
207 |
This is somewhat different than in the MIDI standard. With |
This is somewhat different than in the MIDI standard. With |
208 |
NKSP pitch bend is handled like an additional "regular" MIDI CC controller. |
NKSP pitch bend is handled like an additional "regular" MIDI CC controller. |
209 |
Therefore use |
Therefore use |
210 |
<code>%CC[$VCC_PITCH_BEND]</code> to obtain the current aftertouch value |
<code>%CC[$VCC_PITCH_BEND]</code> to obtain the current pitch bend wheel value |
211 |
in the context of a <code>controller</code> event handler.</td> |
in the context of a <code>controller</code> event handler.</td> |
212 |
</tr> |
</tr> |
213 |
<tr> |
<tr> |